# Failed to build SD image for ZCU111

**URL:** <https://discuss.pynq.io/t/failed-to-build-sd-image-for-zcu111/4579>\
**Category:** Support\
**Created:** [August 23, 2022, 9:12pm UTC](https://discuss.pynq.io/t/failed-to-build-sd-image-for-zcu111/4579 "2022-08-23T21:12:07Z")\
**Posts on this page:** 1\
**Showing post:** 13

<div class="post-metadata">

**Author:** ![briansune](https://sea1.discourse-cdn.com/flex019/user_avatar/discuss.pynq.io/briansune/32/3087_2.png) [@briansune](https://discuss.pynq.io/u/briansune)\
**Post date:** [September 2, 2022, 12:28pm UTC](https://discuss.pynq.io/t/failed-to-build-sd-image-for-zcu111/4579/13 "2022-09-02T12:28:53Z")

</div>

That a bit long:

In my first post instruction, I do mention about bsp issues see:

> [@Failed to build SD image for ZCU111](https://discuss.pynq.io/t/failed-to-build-sd-image-for-zcu111/4579/2):
>
> Hi, Please find the following build guide and issue report:

You can see there are two link 1st targeting general linux environment setup:  
2nd post is targeted ZYNQ-ULTRA-SCALE issues.

I personally built xc7z010 xc7z020 xc7z100 and ZYNQ ultra-scale forgot the part #.  
Above the different boards image build and installed two PCs or even more as virtual environment I am using. There are no GCC issue.  
However, there might be all board build issue which can be ignore by modifying the build.sh and run build command again without “CLEAN”.  
see: [Pynq 2.7 for Zybo-Z7](https://discuss.pynq.io/t/pynq-2-7-for-zybo-z7/4124)

As for IP issue, please setup HDMI license from limited time use and make sure lic is loaded to the virtual environment.

---

_[View the full topic](https://discuss.pynq.io/t/failed-to-build-sd-image-for-zcu111/4579)._