Device: RFSoC 4x2 Kit PYNQ Version: v3.0.1 When I set the transmitter channel amplitude to 0.7 with a frequency of 1500 MHz, the result is smaller than when I set the amplitude to 0.6 with the same frequency. What could be the reason for this? I am using the base notebook `rfdc 02_rf_spectrum_ana…

Dac channel amplitude

cameronpoe May 22, 2025, 4:43pm 2

Did you ever figure out what was happening? The same thing is happening to me.

Unexpected DAC amplitudes when varying gain

Topic		Replies	Views
Unexpected DAC amplitudes when varying gain Support	3	37	June 12, 2025
Code definition location in physical board for 01_rf_dataconverter_introduction Support	0	7	May 13, 2025
RF Data Converter receive carrier wave signal Support	12	122	June 21, 2024
rfsoc_sam dBfs problem Support	0	23	November 4, 2024
Using PYNQ to control RFsoc4*2's dac_block' mixer Support	2	67	October 29, 2024