Does anyone know how to write to the analog pins of the Arduino attached to the PYNQ Z1 ?? Im trying to control the power of a DC motor. I also try to send instructions to a Servomotor but I have no response. Thanks!

The Zynq chip in the Z1 has an ADC connected to these pins, so you can only read analog values, you can’t write them. If you want to write analog values you need a separate DAC. You could get a Pmod DAC; example here: Xilinx/PYNQ/blob/master/boards/Pynq-Z1/base/notebooks/pmod/pmod_dac_adc.i…

Arduino analog pins

Support

marioruiz May 13, 2020, 7:54pm 6

Hello @Susana,

This post PWM on PYNQ_Z2 to a motor may answer your question.

Mario

Topic		Replies	Views
How to give PWM to a motor through a digital pin on PYNQ-Z1 Support	1	724	August 12, 2019
Digital input on PYNQ-Z1 Support	1	775	August 20, 2019
PYNQ GPIO read from PL Support	3	1023	July 9, 2020
Connecting DAC (AD5791) to Pynq- Z1 Support	3	1458	October 31, 2019
Help Accessing Arduino GPIO Support	1	576	October 27, 2020

Arduino analog pins

Related topics