Hello all, I am trying to bring up this block design under PYNQ 2.6 on a ZCU111. [2021-09-17] When I try to load the overlay, I get the following error: [2021-09-16] I found out the block that causes the error is the zynq_ultra_ps_e_0. Clearly, the processor block has no “interrupts” key. Yet…

Key error on Overlay load

jancumps September 18, 2021, 9:36am 2

I used this blog to define a working interrupt: An Example for the PYNQ Interrupt Subsystem

The advise is to use an AXI Interrupt Controller:

2 Likes

Topic		Replies	Views
KeyError : "gpio" while loading overlay Support	12	710	June 13, 2022
IP can't load to PYNQ Z1, but could be found at ip_dict Support	3	618	July 29, 2020
Parse hwh file failed Support	10	905	September 2, 2021
Keyerror in pynq with microZed board Support	5	650	October 13, 2020
PYNQ-Z1, KeyError when downloading overlay Support	3	581	September 12, 2022