RFSoC 4x2 Does not show any IP address in the Display

Support
10

Hello there,

I have finally resolved the problem. Steps to follow to have network access to the RFSoC 4x2 board:

  1. Go the network settings of your host PC
  2. Go to the “Sharing tab” in the “change adapter options” section
  3. Check the two boxes mentioning to allow sharing of the ethernet connection over the network. This allows any external devices (RFSoC 4x2 in this case) connected to your host PC to have internet access.
  4. Then assign a static IP to the “Ethernet” option in your network settings (Realtek USB GbE Family controller in my case since I am using USB to ethernet adapter)
  5. Boot the board and you are all set.

RFSoC ethernet setup
RFSoC ethernet setup960×1280 337 KB

Thank you @cathalmccabe and @skalade for your valuable suggestions.

Regards,
Kefayet

1 Like