Hello,
I am using Pynq RFSoc 4x2 board. However, i am having difficulty to power up the board. I tried images versions v3.0.1 and v2.7, but nothing changes. Done LED and OLED IP doesnt shown as below. Also i added the sd card contents. What is the problem? What can i try next? Thanks.
1 Like
Hi @csarac,
Welcome to the PYNQ community.
How did you flash the PYNQ image into the SD Card?
Have you tried to see if there is any output from the serial, JTAG?
Mario
Thank you for your reply sir.
I bought a new sd card and now it works. But I have a new problem.
As seen in figure, I am getting warning on OLED that “no IP detected”. Also I added my ethernet settings. How can I solve it?
1 Like
Hi @csarac,
I would suggest you connect via the micro USB 3.0. A regular micro USB cable should work.
Mario
Thanks a lot sir.
Were you able to connect to Jupyter?
1 Like
Sir I connected ethernet cable to my pc and i connected to Jupyter. The OLED still displays “no IP connected” but I am able to connect. Thank you for your interest.
For anyone who face this problem can try IP address 192.168.2.99
1 Like
This topic was automatically closed 3 days after the last reply. New replies are no longer allowed.