Help with Z2 start-up

Support
1

All,

I have a brand new Z2 board. It starts up in that I can connect through serial port and ssh to it,access files via Samba

However

  1. The LEDs do not indicate start-up is complete: i.e. the following does not occur:

"After a few seconds, the Yellow/Green / Done LED will light up to show that the Zynq® device is operational.

After a minute you should see two **Blue ** LEDs and four Yellow/Green LEDs flash simultaneously. The Blue LEDs will then turn on and off while the Yellow/Green LEDs remain on. The system is now booted and ready for use."

  1. Jupyter is not started.

Any advice on how to proceed from here would be appreciated. Thanks.

Dobby

2

Hello @Dobby,

Do you have a spare micro SD card? If so, could you flash the latest image there PYNQ - Python productivity for Zynq - Board and try again?

Mario

1 Like
3

Mario,

Thanks. I created a new SD card and things now work as expected.

John

2 Likes