Hi,
I am trying to build PYNQ image for a custom board called Mercury XU6 with a carrier card ST1. I have the petalinux BSP along with it. I am new to Petalinux and am trying to use Pynq v3.0.1 on Ubuntu 22.04.5 OS. I did clone the GitHub repository of PYNQ, source Vitis and petalinux (2022.1)settings, now when I ran the setuphost file, it says the OS was not suitable. However, I tried to create a board repo and then created a spec file, pynq sdist (downloaded), pynq rootfs(downloaded) and ran the make command for my board repo as shown in the pic attached, the make failed. However, initially, I even had a qemu aarch static error, for which I followed the link from the pynq community support (Port PYNQ 3.01 to new board - #3 by briansune ). It looks like it identified the 5.2.0 version; it still shows an error, though, which is ignored. [Attached pdf is an ss of the error]
Screenshot from 2025-05-01 14-43-49.pdf (157.2 KB)
I am not sure about installing the patches and packages mentioned in the config file, or if there is a setuphost file for Ubuntu 22.04 OS.
Any pointers on how to move forward would be greatly appreciated.
Thanks & Regards
RTY